Thingiverse
Tron5.8 EC5 adapter
von tronhelicopters
2
Downloads
2
Likes
0
Makes
This is a EC5 holder for the Tron 5.8
No support needed for the holder.
2x M3x12mm Screws are needed to clamp the 2 parts around the connector. They can directly screw into the plastic without any pre-preparation, no Loctite or glue needed.
No support needed for the holder.
2x M3x12mm Screws are needed to clamp the 2 parts around the connector. They can directly screw into the plastic without any pre-preparation, no Loctite or glue needed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
