Tronxy bed lowering

Well I just got my tronxy X5S in and when I was putting it together I noticed that the bed would hit the nozzle before the Z axis system was all the way up so I designed these bed lowering spacers up...then I printed them and noticed I needed to change the Y / Z limit switch mount to lift the switch up about 2mm so I toke the factory switch mount and remixed it the needed height... all I did was file the factory mount down and drilled 2 new holes to mount the switch. I will more than likely print the new switch mount later but not needed so who knows...

With this spacer setup the new Z printable area is 430mm... which is the max the frame will allow.


OK so I designed up a new control board mount... You will need to print 3 of the mounts whic require 2 m2 bolts each to bolt to the new control panel back plate... It's up to you if you want to print the cover... Now I have not printed any of the control board mount stuff yet so if you print it let me know if it works and how well