tronxy d01 bltouch mount

BLTOUCH mount for Tronxy D01. Needs marlin firmware to enable BLTOUCH.

important! you will also need a bltouch spacer of 5mm thickness

Hardware:
unscrew the top 2 screws of turbo fan (remove completely) and loosen lower two fans of turbo fan (no need to remove lower two) . slide the mount on the top of the turbo fan. put the top two screws back which goes through the turbo fan, the mount and then into the fan shroud. tighten the lower two screws of turbo fan.

wire connections
+5V | + Signal from second unused Filamentsenor
Control Signal | Pin6 at WiFi Socket on Mainboard (refer picture attached for V8 board)
GND | - Signal from second unused Filamentsenor

Zmin | pluged into Zmin (where the switch Sensor was pluged in)
Note: Carefull as one of the pin the 3 pin is +5v. It will permanently damage the bltouch if you connect zmin signal pin of bltouch to +5v.

GND | pluged into GND (where the switch Sensor was pluged in)



The adaption in Marlin where