Thingiverse
Tronxy P802e
von JackJakobs
13
Downloads
5
Likes
0
Makes
Filament guide/cleaner designed specifically for Tronxy P802e with Bowden style extruder.
Print with the longest flat side down.
Add piece of sponge and lubricant then use 10-16mm M3 screw and nut to fasten to hole a few inches below extruder motor. (not sure what the hole was originally intended for but works great for this purpose).
Print with the longest flat side down.
Add piece of sponge and lubricant then use 10-16mm M3 screw and nut to fasten to hole a few inches below extruder motor. (not sure what the hole was originally intended for but works great for this purpose).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
