Thingiverse
TRONXY PRO HEMERA MOUNT (FOR 2020 VERSION)
door boonchin
9
Downloads
8
Likes
1
Makes
*** THIS NEWER BACKPLATE MOUNT WHICH IS DIFFERENT FROM THE PREVIOUS VERSION.
TRIANGLELAB MATRIX (HEMERA) MOUNT FOR TRONXY PRO 330X330 MM.
THIS 3D SKETCH WAS BUILT BASED ON GENERIC TRIANGLELAB MATRIX DIRECT DRIVE EXTRUDER (HEMERA).
VERY MINIMAL LOSS OF PRINT BED AREA. THERE IS A LOSS OF 5MM OF X-AXIS
THE 4 ARMS WAS INTENDED TO ADJUST THE TOTAL PRINTABLE Z-HEIGHT TO 400MM AND ABOUT 15MM OFFSET TO THE FRONT.
SENSOR MOUNT FOR ORIGINAL TRONXY Z-PROBE SENSOR ONLY.
THE NOZZLE_TO_PROBE_DISTANCE WAS X,Y,Z = 35, 0, 0
TRIANGLELAB MATRIX (HEMERA) MOUNT FOR TRONXY PRO 330X330 MM.
THIS 3D SKETCH WAS BUILT BASED ON GENERIC TRIANGLELAB MATRIX DIRECT DRIVE EXTRUDER (HEMERA).
VERY MINIMAL LOSS OF PRINT BED AREA. THERE IS A LOSS OF 5MM OF X-AXIS
THE 4 ARMS WAS INTENDED TO ADJUST THE TOTAL PRINTABLE Z-HEIGHT TO 400MM AND ABOUT 15MM OFFSET TO THE FRONT.
SENSOR MOUNT FOR ORIGINAL TRONXY Z-PROBE SENSOR ONLY.
THE NOZZLE_TO_PROBE_DISTANCE WAS X,Y,Z = 35, 0, 0
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!