Thingiverse
Tronxy spool holder
door danilolattaro
8
Downloads
11
Likes
0
Makes
Spool holder design based on "universal spool holder for 24 - 56mm holes" by RoBotniK.
Designed to fit the Tronxy acrylic spool holder, as it came with a lame PVC pipe.
Shaft has 18.5mm diameter, so will fit even the smallest spool hole from Taulman spools. Shaft bearing surface of the acrylic holder has 19mm wide hole, so it slides well for rotation.
The adapter was designed for printing without supports and to fit 32mm, 38mm, 52mm, 54mm and 56mm diameter spool holes (plus the 19mm hole for Taulman with just the shaft). I searched for all commercial spool sizes and these pretty much sum the bulk of them.
Adapter is supposed to press fit in the spool holes, but my small spool has a round on the edge so I just put a rubber band between it and the shaft.
Tolerance between the adapters and the shaft allows for rotation.
Designed to fit the Tronxy acrylic spool holder, as it came with a lame PVC pipe.
Shaft has 18.5mm diameter, so will fit even the smallest spool hole from Taulman spools. Shaft bearing surface of the acrylic holder has 19mm wide hole, so it slides well for rotation.
The adapter was designed for printing without supports and to fit 32mm, 38mm, 52mm, 54mm and 56mm diameter spool holes (plus the 19mm hole for Taulman with just the shaft). I searched for all commercial spool sizes and these pretty much sum the bulk of them.
Adapter is supposed to press fit in the spool holes, but my small spool has a round on the edge so I just put a rubber band between it and the shaft.
Tolerance between the adapters and the shaft allows for rotation.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!