Troodon Orbiter 2.0 Adapter

This is an adapter I slapped together to fit onto the stock mounting plate, which is made for the Orbiter 1.5 direct drive. Due to the change in mounting geometry, I threw together a part that with a lot of anger, will snap into place over the original mounting hardware. You will need to upgrade your bolts holding the heat sink/hot end to M3-20s. The mounting bolts, I went with the smallest I had on the left, an M3-8. The Right mount was installed with an M3-16. Finally, the little PCB that distributes the left and right fan power needs to be rotated 180 degrees to account for the mounting geometry.

Disclaimer: I don't know what the hell I am doing, so this looks ugly AF. I made it in Tinkercad over a ton of iterations, and I am sure someone can do better. As there wasn't a part anywhere that I could find, here we are. Good luck.