Trunk filet hook - BMW X1

I needed a dedicated trunk filet hook for the car (BMW X1). What a good exercise to learn 3D design and printing ;-)

This hook does not require screw. It can be attached to the trunk floor without creating holes. The hook are "plugged" on the 4 corners of the floor as shown in the pictures.

Nothing specific printing instructions. I did not used support, the result was acceptable without, it's inside a trunk ;-)

I've used Fusion360 to design it. About 8 prototypes before this final design.

Sliced by Cura 4.10

Printed with a Lotmaxx Shark V2.