Thingiverse
Trust GXT 212 Extension
por conraddewet
1
Descargas
0
Likes
0
Makes
Extension for a Trust GXT 212 Microphone.
Need a counter weight for the back as the extension makes it 'top heavy'.
I positioned it with a single foot of the tripod to the front, and two feet to the back.
I used a M5 rounded head bolt with an m5 hex nut that was in my toolbox (I think it is an M5) for the microphone side, and the original bolt/nut for the tripod-side.
For a counter weight I used a binder-clip, clipped to my desk-pad.
Should print good without any supports.
Need a counter weight for the back as the extension makes it 'top heavy'.
I positioned it with a single foot of the tripod to the front, and two feet to the back.
I used a M5 rounded head bolt with an m5 hex nut that was in my toolbox (I think it is an M5) for the microphone side, and the original bolt/nut for the tripod-side.
For a counter weight I used a binder-clip, clipped to my desk-pad.
Should print good without any supports.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
