Thingiverse
Trust Spotlight Bed Mount v2
by C47_3D
5
Downloads
3
Likes
0
Makes
**Bed Mount for Trust Spotlight video camera** with universal clamp (up to 1cm bed thickness)
As I can see it may be working with Hama Spy Protect Camera, as the base look the same
**UPDATED to version V2**
- With more simple design but works much better
- Easier to print
- The clamp is now holding the camera too, not only the mount so no more camera shaking on printer moves
You can use simple claps too (like the ones holding the bad plate).
Then print only 'base_v2' file
*The cutted triangles on the base part should be in front of the video camera when assembling*
See photos (4,5,6) if you will have some problems:
https://www.instagram.com/p/CVVb9PxNRmA/
---
**FIRST version description:**
Trust Spotlight Mount.stl is with all parts excluding 'lens cap' (wich covers the lens to protect from damage or dirt when camera is not used)
To unmount a camera just push both sides of mount to center. You can do this even with mount still on bed.
After the print gen
As I can see it may be working with Hama Spy Protect Camera, as the base look the same
**UPDATED to version V2**
- With more simple design but works much better
- Easier to print
- The clamp is now holding the camera too, not only the mount so no more camera shaking on printer moves
You can use simple claps too (like the ones holding the bad plate).
Then print only 'base_v2' file
*The cutted triangles on the base part should be in front of the video camera when assembling*
See photos (4,5,6) if you will have some problems:
https://www.instagram.com/p/CVVb9PxNRmA/
---
**FIRST version description:**
Trust Spotlight Mount.stl is with all parts excluding 'lens cap' (wich covers the lens to protect from damage or dirt when camera is not used)
To unmount a camera just push both sides of mount to center. You can do this even with mount still on bed.
After the print gen
C47_3D also publishes on
62 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
