MakerWorld
Measure Tools
Zum Modell
Try square ruler hook / wall mount
33
Downloads
10
Likes
21
Makes
A remix for a Try Square (in Dutch: winkelhaak) bracket. I found the original model which was for a IKEA Skadis board but I needed it to just be a flush wall mount. I added/changed the following:Added hole to mount.Added 11mm to the back to have a grip to mount.Increased the flaps on the front by 12mm to give it extra hold while mounted. I found the original size was not always enough to firmly hold the try square.Now you can mount your Try Square to the wall in the garage like me :). Have fun. Printed in:PLA+15% infill, but 5% is just fine2 layers0.2mm per layerNo supports required
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
