Tryhorn (Complete Beyblade)

This is a recreation of an unreleased plastic gen beyblade known as Tryhorn. I didn't know what to call the attack ring, so I named it "horn wall". Other than that, it uses the same parts as described by its Wiki page, being the 8 Balance weight disk and SG Semi-Flat blade base. I have also made a sticker sheet for it, which should measure about 2 13/16 in x 2 3/16 in.

Initially, I had made a new attack ring template based only on feedback about official bit chips not fitting and the model needing to be resized. Then, right after I printed Tryhorn, my official Voltaic Ape 2 arrived in the mail and I found out for myself that a little bit more work would be needed. I put this on hold to update the model files, so that's why the print shown won't quite match up with them.

Credit to Mcup2 and UncleJoJo for the original versions of the bases I used.