Thingiverse
TT02 front splitter
por makeasyougo
54
Descargas
33
Likes
0
Makes
Printed 100% infill
Fitted to a Kenmari
This may or may not fit your chassis/body.
It is attached with two m2 15mm long screws.
**************
6/29/2020 Added 3mm thick splitter with fillet edges. (previously 2.5mm)
Please be careful , if you hit a lip on the road or a large pot hole you may be in danger to flip.(I did do this at Full speed)
Fitted to a Kenmari
This may or may not fit your chassis/body.
It is attached with two m2 15mm long screws.
**************
6/29/2020 Added 3mm thick splitter with fillet edges. (previously 2.5mm)
Please be careful , if you hit a lip on the road or a large pot hole you may be in danger to flip.(I did do this at Full speed)
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
