Thingiverse
TTGO T-Beam Meshtastic
von mwawrzyn
43
Downloads
38
Likes
0
Makes
This is a revised case design to fit the screen soldered directly to the goldpins on the board. The housing allows you easily press the buttons directly with your finger. Each button makes 'click' when pressed. To be sure, the case back is attached with screws, but if you don't want to, it stays closed also without them.
Don't worry, my logo won't be printed on a 3D printer.
I printed these from the PLA. 5 hours bottom of the case and 1 hour top lid.
Don't worry, my logo won't be printed on a 3D printer.
I printed these from the PLA. 5 hours bottom of the case and 1 hour top lid.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
