Thingiverse
TTGO T4 Case
by dstarke
0
Downloads
0
Likes
0
Makes
A case for the TTGO T4 v1.3 ESP32 development board.
Only two of three buttons are available as the remaining one is also connected to an internal sensor and therefore not fully usable as user button. Furthermore, boot and reset switches are not made accessible from outside as these are only needed during development and not during operation.
Necessary for assembly:
- 4x M2x12mm
Note that it is not necessary to drill threads into the bottom part if printed with the correct tolerance.
Only two of three buttons are available as the remaining one is also connected to an internal sensor and therefore not fully usable as user button. Furthermore, boot and reset switches are not made accessible from outside as these are only needed during development and not during operation.
Necessary for assembly:
- 4x M2x12mm
Note that it is not necessary to drill threads into the bottom part if printed with the correct tolerance.
dstarke also publishes on
42 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
