Tube Endcap Keystone Mount

I wanted to mount an ethernet keystone jack at the end of the gantry tubes on my MPCNC to drive the opposing stepper motor. There were existing mounts here on Thingiverse, but the ones I tried didn't fit my cat6 keystones or the 1-inch/25.4mm stainless tubing I've used for the gantry and rails.

The keystone jack mounts upsidedown giving you access to the punch downs, and there is a small access port at the front to allow you to reach the release clip if you need to take it out.

The included cap covers the exposed wires and press fits onto the body.

There are a couple of test files I generated to check fitting of my design against the tube and my keystones. Printing these takes more like 10 minutes and can confirm if the keystones you plan to use will fit.

The keystones I used: https://www.amazon.co.uk/gp/product/B00IO3HEN6/