Thingiverse
tube joiner
by bramfam
3
Downloads
4
Likes
0
Makes
I had a broken Aircon drain tube, so I came up with this simple design.
Version 2, has one end with a softened edge to allow the water to flow easier.
I used PLA to print, with no supports. On my Hictop, it took about 30 minutes to print at a resolution of 0.06.
Version 2, has one end with a softened edge to allow the water to flow easier.
I used PLA to print, with no supports. On my Hictop, it took about 30 minutes to print at a resolution of 0.06.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!