Thingiverse
Tubular spool holder
von Lollixx
1
Downloads
5
Likes
0
Makes
Spool holder made with some printed parts and 16mm alu tubes
The lenght of the tubes isn't so important but the legs must be long the same or the holder will wobble.
I used 2x150mm for the legs and 1x120mm for the one inside the spool
Clearances are pretty tight because it's I didn't glued anything so I suggest to heat up the pieces before pushing the tubes in or something may crack
The lenght of the tubes isn't so important but the legs must be long the same or the holder will wobble.
I used 2x150mm for the legs and 1x120mm for the one inside the spool
Clearances are pretty tight because it's I didn't glued anything so I suggest to heat up the pieces before pushing the tubes in or something may crack
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
