Thingiverse
Tulip Flower
door JosueGar
8
Downloads
7
Likes
0
Makes
Tulip flower
Size: Bin- 40mm (L) 40mm (W) 52mm (H)
Filament: 14g of 1.75mm
Infill: 10%
Time: Approximately 2.5 hours
Made by: Josue G.
There is no special base I made to hold the tulip upright. It has a rounded bottom with no stem. I did, however, add detail to the inside of the flower. you can see it when you view it from the top.
I used support branches to hold the base.
Good luck and have fun!
Size: Bin- 40mm (L) 40mm (W) 52mm (H)
Filament: 14g of 1.75mm
Infill: 10%
Time: Approximately 2.5 hours
Made by: Josue G.
There is no special base I made to hold the tulip upright. It has a rounded bottom with no stem. I did, however, add detail to the inside of the flower. you can see it when you view it from the top.
I used support branches to hold the base.
Good luck and have fun!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!