Thingiverse
Tumbler Drum
por EelAudio
14
Descargas
13
Likes
0
Makes
This drum has ribs inside to help toss the media each revolution. The drum is about 8.2 in wide at its fattest point. Connect to it using a 1" diameter rod, or a plate with 6 holes in it, or both! I would recommend printing it from something sturdy that can take the impact of the tumbling media.
The 0.3 in hole is meant to fit a heat-set threaded insert (part number 93365A160 from McMaster Carr).
All annotations are in inches.
Edit: Made the fins inside smaller and added a better lip for attaching a lid. This lip is 0.25 in tall, with an OD of 5.2 in.
The 0.3 in hole is meant to fit a heat-set threaded insert (part number 93365A160 from McMaster Carr).
All annotations are in inches.
Edit: Made the fins inside smaller and added a better lip for attaching a lid. This lip is 0.25 in tall, with an OD of 5.2 in.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
