Tuna Can Ring

Tuna can shaped ring with half open lid.

*This is a project made in class, be aware I don't own a printer and don't have tecnical knowledge"

NOTES:
-When printing, I scaled all the components of the tuna can itself to 120% on Ultimaker Cura, for it's original size was too small to my likings. The ring itself remained the same size. Please scale the ring acording to your finger size.

-Please scale the tuna filling to be a little smaller than its original size, for I didn't properly calculated it and the filling didn't fit at all.

-I took off the top layer off the tuna on Ultimaker Cura to preserve the infill texture. I recommend the Gyroid infill at 70% density.