Thingiverse
Turbine Centrif
von drjcpp
37
Downloads
23
Likes
0
Makes
Taller and with 8.5mm shaft hole.
NOTES IMPORTANT:
1. I used this with a 300W motor and the blades flew off. Either they were too thin, motor too powerful or both.
2. Stronger if sliced with Cura not Sli3r a 0.222 layer and 100% infill
NOTES IMPORTANT:
1. I used this with a 300W motor and the blades flew off. Either they were too thin, motor too powerful or both.
2. Stronger if sliced with Cura not Sli3r a 0.222 layer and 100% infill
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
