Thingiverse
Turbine Speaker
door Cover1987
132
Downloads
106
Likes
2
Makes
This is my desing of an speaker housing for an Tang Band W4-655 speaker (propably other speaker also fit in, you can tell me and I will add them). This speaker is a very cheap ( ~40€ each speaker - i use 2 for stereo; other compareable speaker cost around 100€/speaker) HiFi speaker with very low clink and 40W power (80W music) with a bandwith from 70Hz-14000Hz
The housing is specal designed for the Tang Band W4-655 speaker with a bass reflex channel to have a quiet small housing to use them as PC speaker at your desk. So the volume and the bass refelx channel is tuned for the speaker.
Properties of the speaker are:
Resonant frequency fS 70 Hz
Electrical Q QES 0.31
Mechanical Q QMS 5.57
Total Q factor QTS 0.29
Suspension equivalent air volume VAS 6.01 litres
DC resistance RE 6 Ω
Voice coil inductance LE 0.124 mH
Force factor B·l 5.84 T·m
Mechanical resistance RMS 0.3 N·s/m
Suspension mechanical compliance CMS 1303 µm/N
Moving mass MMD 3.7 g
Moving mass (including
The housing is specal designed for the Tang Band W4-655 speaker with a bass reflex channel to have a quiet small housing to use them as PC speaker at your desk. So the volume and the bass refelx channel is tuned for the speaker.
Properties of the speaker are:
Resonant frequency fS 70 Hz
Electrical Q QES 0.31
Mechanical Q QMS 5.57
Total Q factor QTS 0.29
Suspension equivalent air volume VAS 6.01 litres
DC resistance RE 6 Ω
Voice coil inductance LE 0.124 mH
Force factor B·l 5.84 T·m
Mechanical resistance RMS 0.3 N·s/m
Suspension mechanical compliance CMS 1303 µm/N
Moving mass MMD 3.7 g
Moving mass (including
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!