Turbo

The design is originally from a project. The "turbine" is driven by a drone motor currently (about 8.5mm diameter) it gets to hot right now to be sustainable for long term use and makes a lot of noise. Version 1 is not really a proper compressor and I wouldn't recommend it however that one I can guarantee the parts will fit together and it does move air. Version 2 is a bit more advanced and adheres more to a proper turbo, however tolerancing it exceeding tight (if nonexistent). Its mainly designed for Resin printing but I have been using an FDM and Cura as resin is expensive.

[PARTS LIST]
[V 2.2]:

Motor:
https://www.amazon.com/WORKER-Motor-Bearing-Stryfe-Rapidstrike/dp/B07SDBB7YM/ref=sr_1_32?dchild=1&keywords=High+efficiency+high+rpm+motor&qid=1613524456&sr=8-32

Power: I am currently using a 9 Volt battery to power it,

Fasteners: I am unable to find the correct fasteners online, I'm really not sure, If you plan on building take it to the hardware store and find what yo