Turtle Beach flight yoke support

When using the Turtle Beach yoke, I felt a slight rubbing when pulling up or pushing down and there was a very small amount of play in the yoke shaft, possibly caused by the weight of the handle assembly. It's a minor problem, but I found that adding a support to the yoke shaft helped. To construct one of these you'll need 8 X 3/4 inch wood screws (rounded head), half inch steel ball bearings and some oily glue (Amazon has the glue and ball bearings). Mine is printed in PETG and oily glue is about the only stuff I've found that works with it.
You'll need to print two copies of the bearing base and top, one coupling base and one each of the threePoint files. The bearing holders are a press fit and might require a little tap with a mallet to fully seat.
Anyhow, if you've noticed the issue and it bothers you, this might help.