Thingiverse
Tush stand
door DividedPage
27
Downloads
10
Likes
1
Makes
A stand for the TUSH spool holder.
I made this model as the way I had my filament it would make the TUSH slide or fall apart,
and a lot of other designs dont have a back on the stand and aren't as easy to put screw holes in.
I made a second file for ones with holes for mounting and a 3rd with a single centre hole,
to keep the stands in place this design is fine by itself but if you want a bit more of a rigid solution you could stick rubber feet to the bottom or screw them down.
I made this model as the way I had my filament it would make the TUSH slide or fall apart,
and a lot of other designs dont have a back on the stand and aren't as easy to put screw holes in.
I made a second file for ones with holes for mounting and a 3rd with a single centre hole,
to keep the stands in place this design is fine by itself but if you want a bit more of a rigid solution you could stick rubber feet to the bottom or screw them down.
DividedPage publiceert ook op
3 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
