MakerWorld
Hueforge & Lithophane
Zum Modell
Tuxedo Cat Bookmark
23
Downloads
22
Likes
13
Makes
Beautiful tuxedo cat. No AMS needed, you can manually set pauses instead of filament changes. Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 50x149.8mm in sizeYou may print at higher layer heights below the Min Depth of 0.48mmThe Max Depth is 2.2mm and the Actual Depth is 2.3mm This print uses 3 unique filamentsSwap Instructions: Start with Black At layer #8 (0.72mm) swap to Gray At layer #14 (1.2mm) swap to Jade White for the rest.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
