Thingiverse
Tuya Water Sensor Clip
von Monorchid
1
Downloads
0
Likes
0
Makes
Made a few adjustments:
Increased the size of the clip band slightly, as it was too small on my sensors originally.
Added a wall hole mount instead of a floor mount; Make sure to not overtorque it as it will cause your sensor to tilt slightly.
Drilling a pilot hole first as well is recommended to make sure you have the clip as level as possible with the ground.
Increased the size of the clip band slightly, as it was too small on my sensors originally.
Added a wall hole mount instead of a floor mount; Make sure to not overtorque it as it will cause your sensor to tilt slightly.
Drilling a pilot hole first as well is recommended to make sure you have the clip as level as possible with the ground.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!