Tweezer Grip SMD testing

Original credit to Maldam on Reddit for his post. This is a nice way to turn ESD tweezers into testing probes. To build you need to separate the tweezers, I used a razor blade and hammer for extra danger! Then re-bend to straight. You will need banana plug wire, SMD tweezers, heat shrink and soldering equipment.12% or higher infill, brim 5-6mm and no support needed. ***These are for wiha branded tweezer, please print and verify hole size for other brands, if you leave a comment I can make a few different brand versions. Super glue or epoxy is what is needed to make sure they hold in place. I used thermal epoxy as it was what I had in hand just don't let the glue short the leads as it may throw off readings. ** reduced the distance of the tweezer holes as to allow for less finger fatigue.