Twirly Gig 4

If you stare at it too long you will time-travel into the future and we won't be able to bring you back. Yes, there is a Twirly Gig for the A1 MINI! Prints without an AMS and uses minimal supports on just a few pieces (and they are easy to remove). It can be set up to run from a TT Motor with speed controller (both available through the Bambu store) or with a hand crank. If you are building it with the hand crank, you do not need to print the plate with the motor parts, and vice-versa. If using the TT motor, the speed controller is also required. If you don't use the speed controller, the motor spins too fast. This is the fourth in a series of Twirly Gig kinetic sculptures by Jim Larsen. The twirly discs are interchangeable between models so you can collect them all and run them from the same base. In some cases you will need to change the upper axle for compatibility. See it in motion:Assembly Instructions: If you like kinetic sculptures you can find more in my Twirly Gig coll