Thingiverse
Twisted vase with strands
door alecs_form
2.7k
Downloads
2.2k
Likes
11
Makes
Twisted vase with strands.
An experiment on introducing stiffness into a thin wall structure by adding strands of filament on both sides of a shell. The shell itself is a parametric modell, the strands are attached to specific points in a repeating manner. They're printed by extruding material "into the air". This technique is called bridging, because it doesn't make use of support structures. Each strand consist of two layers. This leads to a very stiff structure, which won't deform when squeezed. The diameter of the vase is about 90mm, the height ~200mm.
Geometry was created using Rhino/Grasshopper.
An experiment on introducing stiffness into a thin wall structure by adding strands of filament on both sides of a shell. The shell itself is a parametric modell, the strands are attached to specific points in a repeating manner. They're printed by extruding material "into the air". This technique is called bridging, because it doesn't make use of support structures. Each strand consist of two layers. This leads to a very stiff structure, which won't deform when squeezed. The diameter of the vase is about 90mm, the height ~200mm.
Geometry was created using Rhino/Grasshopper.
alecs_form publiceert ook op
11 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
