Thingiverse
Twister servo winch
di Runfrcover
14
Download
13
Likes
0
Makes
Base and spool for an RC4WD Twister servo.
This is the easiest to mod servo I have yet seen! Pull the output gear stop pin, remove the circuit board, unclip the pot, cut away its mount, cut open the case end or side, done!
Printed base includes mounting for a 5x11x4 bearing, std on most crawlers and a secondary mount tab for mounting options.
Spool uses an M3 set screw.
M3x50, lock nut and M3x7mm washer for main shaft.
This is the easiest to mod servo I have yet seen! Pull the output gear stop pin, remove the circuit board, unclip the pot, cut away its mount, cut open the case end or side, done!
Printed base includes mounting for a 5x11x4 bearing, std on most crawlers and a secondary mount tab for mounting options.
Spool uses an M3 set screw.
M3x50, lock nut and M3x7mm washer for main shaft.
Runfrcover pubblica anche su
19 modelli aggiuntivi su altre 1 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!