Thingiverse
Two Button Case - snap together
par jhawkn8r
1
Téléchargements
4
Likes
0
Makes
Started as a remix, but I ended up just making it from scratch in Tinkercad to keep everything clean.
The original was a bit too big and had some extra nubs that used up plastic that I didn't want. Also having screws that fit was kind of a pain. This version is smaller - 70x70x25mm. The bottom snaps on tightly and can fit all the way flat or just slightly out - the example is not all the way pushed in. The 2 holes are 13mm and fit my standard pushbuttons nice and snug with no adjustment.
In the example box, one of my buttons turns on my printer LED's and the second dims (turns off 1/2 of the LED's). I also included a small hole for my IR sensor to control color if I want.
The original was a bit too big and had some extra nubs that used up plastic that I didn't want. Also having screws that fit was kind of a pain. This version is smaller - 70x70x25mm. The bottom snaps on tightly and can fit all the way flat or just slightly out - the example is not all the way pushed in. The 2 holes are 13mm and fit my standard pushbuttons nice and snug with no adjustment.
In the example box, one of my buttons turns on my printer LED's and the second dims (turns off 1/2 of the LED's). I also included a small hole for my IR sensor to control color if I want.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
