Thingiverse
Two Hearts Lamp / box
by C47_3D
16
Downloads
18
Likes
0
Makes
**TWO HEARTS** in 3 parts (base and 2 covers) that can be used as a **LAMP** (hanging or standing) or a **BOX**
---
For a lamp you will need around 1,1m of LED tape - for full 2 hearts (LED on both sides of the middle wall)
Or less - with LED tape on the right heart and partially on the left one (LED on the middle wall only on the right heart side)
Lamp has 3 holes, one to hang it on the wall and two for a cable (I may make a plugs to cover it if needed)
Box has no holes and is much taller
---
**Both needs 240mm+ bed**
With 90% size on X and Y axis and setting line width to 0.35mm (to have walls with 3 full lines) in your slicer it may be printed on 215mm+ bed
---
2 WiP photos with standing lamp
https://www.instagram.com/p/CKzXPcarjuD/
---
---
For a lamp you will need around 1,1m of LED tape - for full 2 hearts (LED on both sides of the middle wall)
Or less - with LED tape on the right heart and partially on the left one (LED on the middle wall only on the right heart side)
Lamp has 3 holes, one to hang it on the wall and two for a cable (I may make a plugs to cover it if needed)
Box has no holes and is much taller
---
**Both needs 240mm+ bed**
With 90% size on X and Y axis and setting line width to 0.35mm (to have walls with 3 full lines) in your slicer it may be printed on 215mm+ bed
---
2 WiP photos with standing lamp
https://www.instagram.com/p/CKzXPcarjuD/
---
C47_3D also publishes on
63 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
