Two-Layer Pixel 3 Case - with scad files

Well, phone cases are expensive, especially the good ones. If you have a Pixel 3 and have wondered how you will keep it scratch-free, here's one possibility.
I've always liked the ones with the mushy layer inside and the hard shell exterior, so that's how I made this one.
Please note that you should make the outer case from PETG, and not from PLA. I tried PLA and it's pretty stiff.
The under layer is designed to be made with NinjaFlex.

If you saw this on 2 November 2018, please note that I've since uploaded new .stl files. These include the hole for the third microphone (on the top edge of the phone, directly over the camera lens). I've also widened the screen-window-space to make it easier to reach links on the screen that are located close to the edges of the phone case.

On 5 November, 2018, I updated again. I've added a NinjaFlex case that doesn't have a hole for the buttons. Instead, I raised the strips of material over the buttons. NinjaFlex is difficult to wor