Two part low poly mannequin model

I used Prusa Slice 2.6 to split the original one piece model at the neck such that the head piece needs minimal support (ears and a little bit of the neck very close to the build plate. This is scaled up from the original (20% IIRC) to be a more realistic size as the original was a little on the small side.I added connectors as I was doing it to help join them accurately after. But I'm not sure how well those really helped in practice as I had some silk-related quality issues as I printed this for myself.Even with lightning infill this print will use most of a roll (800g-ish from memory). Other infill bump up print time and filament usage considerably.Things I found printing it:0.28mm layer height meant a lot of the lower angle poly surfaces looked awful and felt even worse (like sandpaper).Dropping to 0.08mm layer height helped a lot with only the nearest horizontal poly surfaces still being somewhat poor.Turning off the ‘single wall on top surface’ setting made a huge difference to b