Two-Tiered Synthesizer Stand

This is my first 3D object ever made, it's a bit rough but works fine.

The stands are inclined 25° for better reach. They have a 1cm stop-wall for preventing the synth from sliding down. The stands are 20cm wide and 16cm deep.
The stand as a whole is mostly empty to get cables across without having them in the way, it's also open on front for the same reason.
I had to cut it in 4 pieces before printing to avoid using supports. I glued it togheter in the middle and used velcro cable straps for locking the 1st and the 2nd stand togheter, so i can later disassembe it (or use them separatedly.)

Bambulab P1P
PLA+
No supports
5% infull Gyroid