Thingiverse
Two-Tone Vase
by jashooas
14
Downloads
15
Likes
1
Makes
My 2nd try on a vase design!
- Original Z-size: 150 mm (scaled to 180 mm without any problem)
- Size of prototype: 120 mm
Printer settings on Prusa i3 MK3S (slicing done with PrusaSlicer 2.1):
- remove top layer and infill!
- Layer height: 0.25 mm (also 1st layer) - use quality filament!!
- Vertical shells: 2
- Horizontal shells: bottom = 4 | top = 0
- Infill: 0 %
- Support material: necessary only for the half where the bevel dovetail goes inside the vase
- Temp settings: first layer = 205° | second layer = 200°
- Watertight = NO (use liquid rubber spray like "Plasti Dip" to make it watertight after the print).
Filaments used - all PLA (see pictures):
- Fillamentum "Extrafill Crystal Clear Iceland Blue"
- Eryone Transparent
- Prusament "Vanilla white" (Prototype)
- OWL Filaments "Petrol" (Prototype)
- Original Z-size: 150 mm (scaled to 180 mm without any problem)
- Size of prototype: 120 mm
Printer settings on Prusa i3 MK3S (slicing done with PrusaSlicer 2.1):
- remove top layer and infill!
- Layer height: 0.25 mm (also 1st layer) - use quality filament!!
- Vertical shells: 2
- Horizontal shells: bottom = 4 | top = 0
- Infill: 0 %
- Support material: necessary only for the half where the bevel dovetail goes inside the vase
- Temp settings: first layer = 205° | second layer = 200°
- Watertight = NO (use liquid rubber spray like "Plasti Dip" to make it watertight after the print).
Filaments used - all PLA (see pictures):
- Fillamentum "Extrafill Crystal Clear Iceland Blue"
- Eryone Transparent
- Prusament "Vanilla white" (Prototype)
- OWL Filaments "Petrol" (Prototype)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
