Thingiverse
Two Trees Bluer Plus Z-axis holders
von FiReStiLL
14
Downloads
7
Likes
0
Makes
Z-axis holders for Two Trees Bluer Plus.
Original holders on my printer was broken, so I designed new.
Here you will find left (L) and right (R) holders and caps for original bearing.
For mounting holders and bearings caps I used 2 x M5x15 mm and 2 x M3x8 mm screws (see photo).
Used filament PLA or PET-G
Layers height - 0.2 mm
Support - YES
Infill - 50-100%
Original holders on my printer was broken, so I designed new.
Here you will find left (L) and right (R) holders and caps for original bearing.
For mounting holders and bearings caps I used 2 x M5x15 mm and 2 x M3x8 mm screws (see photo).
Used filament PLA or PET-G
Layers height - 0.2 mm
Support - YES
Infill - 50-100%
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
