Thingiverse
Two Trees Sapphire Led Strip 2020
por hetile
145
Descargas
114
Likes
0
Makes
PLEASE POST A MAKE IF YOU PRINT!
This is a remix of [J-MAX](https://www.thingiverse.com/J-Max/about) 2020 led mount to fit the Sapphire S.
Modification made:
- I lowered the inner clip to make them stronger so they stay in place once clipped
- I removed part of the side of the mount so that it could still be used if you have a Sapphire S3 (with the enclosure).
I used 2 led strip of 12v that I connected in serie (see image) to the 24v output of the board. You can control the led from the menu.
NOTE: Print this in VASE mode standing vertically which sapphire has no problem. I printed 2 at 185mm height then some cable management clip-tube (will post a link soon)
This is a remix of [J-MAX](https://www.thingiverse.com/J-Max/about) 2020 led mount to fit the Sapphire S.
Modification made:
- I lowered the inner clip to make them stronger so they stay in place once clipped
- I removed part of the side of the mount so that it could still be used if you have a Sapphire S3 (with the enclosure).
I used 2 led strip of 12v that I connected in serie (see image) to the 24v output of the board. You can control the led from the menu.
NOTE: Print this in VASE mode standing vertically which sapphire has no problem. I printed 2 at 185mm height then some cable management clip-tube (will post a link soon)
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
