TwoTrees Sapphire S upgrades

i made a few small upgrades for my TT Sapphire printer.There is an endstop mount for the X endstop switch. you might need some shorter than stock m2 screws to mount the endstop to the part.There is a modified stepper motor mount for the X and Y motors, with this mount you can get rid of the 8mm steel rods, thus eliminating a lot of rotating mass, to reduce the ringing effect on the prints. since the stock pulleys fit for the 8mm rods, you will need an adapter for the 5mm shaft of the stepper. so i quickly designed an adapter. easy to print, it's a bit tight on the shaft, but you don't have to get new pulleys... no additional hardware needed, only the stock screws.and for last, there is a modified extruder mount. it is designed to relocate the extruder thus reducing the length of the ptfe tube. it is made from 2 parts, because it has to be mounted to the 6mm top plate. you will need 2 M3 12-14mm screw and one M3 8mm. with this mount my printer runs perfectly with only 40 cm of capricorn