Thingiverse
Type2 charger holder
door annttu
0
Downloads
0
Likes
0
Makes
Type2 charger holder for Garo PP enclosures.
Note: Select either type2-cone-forward or type2-cone-backward matching your need before printing.
Assemble type2 cone to side plate using two m4x20 screws and hex nuts.
Install bottom cover inside the cone.
Unscrew two top screws from the Garo enclosure and place side plate on. Use two m4x40 or m4x50 to secure side plate in place.
No drilling required! This model reuses original screw holes in the enclosure.
Make sure you have permission to do modifications to the enclosure before installing this!
Note: Select either type2-cone-forward or type2-cone-backward matching your need before printing.
Assemble type2 cone to side plate using two m4x20 screws and hex nuts.
Install bottom cover inside the cone.
Unscrew two top screws from the Garo enclosure and place side plate on. Use two m4x40 or m4x50 to secure side plate in place.
No drilling required! This model reuses original screw holes in the enclosure.
Make sure you have permission to do modifications to the enclosure before installing this!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
