Thingiverse
U30 Extruder
door cheerio123
43
Downloads
34
Likes
0
Makes
This is a replacement for the original Extruder. You have to put PTFE tubes in the the Parts so that the Filament runs through them. I designed this because the original Extruder was squeaking sometimes due to the filament rubbing on it. Everything is a tight fit so depending on your printer calibration you need to do some finishing by hand.
cheerio123 publiceert ook op
3 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!