Thingiverse
Uber Logo w/Mounts
by wseibert
1
Downloads
1
Likes
0
Makes
Designed the Uber logo so it can be hung on the inside of a car with some Suction cups (found at WalMart, pictured).
Mounts added to back of Logo for Suction cups to slide into. They fit snug and don't move once they have been put into the slides.
6mm version is lighter and may hold onto slanted windows a bit better.
Clean the window good and apply a little oil (Olive oil will work) to the suction cup. This will help insure the suctions cups hold on good. Not much oil is needed, just a very light/thin layer. You can just add a drop to a tissue and wipe over the suction cup.
Mounts added to back of Logo for Suction cups to slide into. They fit snug and don't move once they have been put into the slides.
6mm version is lighter and may hold onto slanted windows a bit better.
Clean the window good and apply a little oil (Olive oil will work) to the suction cup. This will help insure the suctions cups hold on good. Not much oil is needed, just a very light/thin layer. You can just add a drop to a tissue and wipe over the suction cup.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
