Thingiverse
Ubiquiti G3 Flex Ceiling Mount
door HikerGlenn
16
Downloads
11
Likes
0
Makes
* Suitable for suspended ceilings or paneling
* Print without supports as long as you can bridge 2 inches.
* The mounting holes for the G3 Flex and reset button have a single layer to support printing the lid without supports but can be simply poked thru with an awl or screw to open up.
1. Mount the G3 Flex to the shell insert piece
2. Drill a 2 3/8 inch hole in the ceiling (2 1/4 for tight fit)
3. Insert the shell insert and screw on the clamp ring until tight
4. Plug in your cable and enjoy
* Print without supports as long as you can bridge 2 inches.
* The mounting holes for the G3 Flex and reset button have a single layer to support printing the lid without supports but can be simply poked thru with an awl or screw to open up.
1. Mount the G3 Flex to the shell insert piece
2. Drill a 2 3/8 inch hole in the ceiling (2 1/4 for tight fit)
3. Insert the shell insert and screw on the clamp ring until tight
4. Plug in your cable and enjoy
HikerGlenn publiceert ook op
4 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
