uBITX radio project

This is my on going Ubitx project.

Feel free to use parts you have a use for.

I print most bits in ABS, being in the sun or car will not effect it.
ABS need brim 10mm, a charmer around your printer to keep the temp constant.

uBitx 50mm speaker grill, this version needs ironing on the top layer to make it look smooth.
uBitx 50mm speaker grill 2 has no label, a blank spot for your own or the uBitx logo.

different styles of VFO knobs to your liking.

Spacer for 50mm square mount speaker to clear cone, Nextion screen spacer to make screen flush with front. a 50mm round speaker mount/ spacer.

The logo just prints with a 0.4 tip but go 0.2 or 0.3 if you could be bothered. I was lazy to change my tip.

I printed the no label version face up. I then wet rub the top with 400, 600, 1000 and a rag to get a shine.

Acetone misted may come up to shiny but a scotch pad to rough it up a bit.

The radio case will have protective plastic side caps to finish it off, optional