UDOO Bolt M.2 Conversion

This is a 20mm long conversion to allow a SATA 2280 (key-M) SSD to fit into the Bolt's M.2 slot that is 2260 (key-B). The problem is that the Bolt's key-M slot is NVMe only, and all I had were SATA M.2 drives available. The Bolt's key-B slot however uses the SATA protocol, but the slot is only 2260 in size. This slips over the post for fastening the key-B and extends the post another 20mm, allowing the user to insert an M3 nut into the printed part, and use the original screw to tighten down the M.2 drive. This has been tested.