UK65 case - vase mode

This is a remix of the original UK65 case by Thump2010:
https://www.thingiverse.com/thing:3240856

It is a two-part storage case for 65mm FPV drones, with separate top and bottom pieces.

I recreated the model with the same overall dimensions, but optimized it for spiral vase mode printing and easier printing of the curved overhanging corners. The parts are compatible with the original model, so you can mix and match the top and bottom pieces between this version and the original design.

No supports are required.

Recommended print settings:

For spiral vase mode:
- Use vase / spiralize outer contour mode
- Wall thickness: 1 mm
- Bottom thickness: at least 1 mm
- Top layers: 0
- Infill: not applicable / 0%

For normal printing:
- Infill: 0%
- Adjust the number of walls/perimeters so the final wall thickness is as close to 1mm as possible, especially for the top piece
- The bottom piece can be printed with any wall thickness you prefer

Material suggestions:
- PETG
- ABS
- PLA

PETG o