Thingiverse
Ukelele support / stand (wall mount)
von marcegonzs
19
Downloads
24
Likes
0
Makes
ABS is recommended but PLA also works, over time the PLA will have a little deformation depending on the brand you use.
Print the ukulele stand as one piece with active supports all over, then remove them very carefully when you are done printing.
Print the ukulele stand as one piece with active supports all over, then remove them very carefully when you are done printing.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!