ULA Rocket Bracket Challenge Entry

Description of the bracket: The ULA CAD Challenge launch support bracket was designed with consideration for the load bearing flat face, bolt stress distribution, potential for an ease of installation for a work platform, uniformity of design for ease of additive manufacturing. Good luck to everyone participating in this challenge. It has been quite a learning experience! All wall thicknesses are above 0.04". Material Properties: Density of material: 0.048 lb/in^3 (~1.33g/cm^3) Young's Modulus: 3.25E+05 psi Poisson's Ratio: 0.41 Shear Modulus: Set to 1.450E-03 psi General Properties: Mass: 0.082 lbmass Area: 21.473 in^2 Volume: 1.690 in^3 Stress analysis for Von Mises Stress on flat face load support: Von Mises Max: 2.622 ksi 1st Principal Stress Max: 3.453 ksi 3rd Principal Stress Max: 0.815 ksi Displacement Maximum: 0.007975 in Center of Gravity: 0.086 in 0.858 in 0.000 in